CamCraft

Multi-axis

5-axis simultaneous

In simultaneous 5-axis work the part stands still and the tool axis moves on every move, while the linear axes follow. CamCraft has seven operations for it (5-Axis Contour, 5-Axis Parallel, 5-Axis Flow, Swarf, Advanced Swarf, Multi-Axis Rough and Multi-Axis Contour), all in the Multi-axis group. Each operation's settings, defaults, lead, lag, max tilt, shank avoidance and refusals are in the Multi-axis operations reference. This page covers what that reference leaves out: what the machine and post must offer, the checks, and a recipe.

What it needs

  • A machine that tilts in two directions: tilthead.mch is the only shipped file with two tilting rotaries. The Doosan and microARC 4 files have a single A table, which can reach a pose only in the plane across A; the machine check refuses a pose it cannot reach.
  • A post that writes TCP: fanuc.cps or doosan-dnm.cps. Every other shipped post refuses a tilted move, so a 5-axis program does not post with them. There is no 5-axis post for Heidenhain, Siemens, Haas or Mazak yet.

Checks

See Checks. In short: the machine check judges the posed moves against rotary travel, the leaning-tool reach laws judge the shank and holder against the part and fixtures, and the stock simulation does not judge posed programs.

Recipe: finishing a ruled wall with Swarf

  1. Mount tilthead.mch with fanuc.cps or doosan-dnm.cps.
  2. Import a part with a ruled wall (a bladed or tapered side wall).
  3. Add Swarf with a flat or bull-nose tool. Leave lead and lag at zero, set Max tilt to 90, and leave Stepover empty so the tolerance sets it.
  4. Run it. If the model is doubly curved, the refusal names it; use 5-Axis Parallel instead.
  5. Post, then read the machine check and any warnings before cutting.

Not implemented

  • Singularity detection or avoidance: CamCraft does not model what a control does when a rotary passes through a pole.
  • Collision of the machine's own spindle and head body against the work. Machine files can state a spindle body size, but no check uses it; the checks cover the tool, shank, holder and fixtures.
  • Judging a posed program in the stock simulation.