Toolpath strategy
The principles
Conventional roughing clears a pocket in offset rings or a raster. At corners and when a ring closes, the tool suddenly engages more material, so the load spikes. Feed and depth must be set for the worst point.
Adaptive (constant engagement) roughing shapes the path so the tool's engagement stays near a set limit everywhere, with arcs instead of sharp turns. Because the load is steady, it allows a deeper axial cut and a higher feed, and spreads wear along the whole flute length.
Climb versus conventional milling. In climb milling the tool rotates with the feed at the contact point: the chip starts thick and ends thin. It usually gives a better finish and less rubbing, and pulls the tool into the cut, so it needs a machine without backlash. Conventional milling starts thin and ends thick, and pushes the tool away. Roughing a hard surface scale sometimes favours it. Climb is the usual default.
Choosing a finishing strategy by surface. Steep walls suit passes that follow constant Z levels (waterline). Shallow and flat areas suit passes that follow the surface in a raster, because on a waterline pass the spacing grows as the surface flattens. Floors suit a single flat pass. Most 3D parts need both: split by slope, so each strategy cuts the surfaces it is good at.
Rest machining. After a large tool, material stays in corners and narrow areas. A later operation with a smaller tool can be limited to just those areas instead of re-cutting everything.
What CamCraft does
- Adaptive is an operation kind (2D), with a Max engagement angle, Forward step, Stock to leave and a choice of how the tool returns between passes. The 3D pocket also has an adaptive strategy per level.
- Climb milling is a check box on the Feeds tab of the milling kinds.
- 3D Finish offers several patterns: Waterline, Parallel, Scallop, Radial, Spiral, Contour, Project, Steep/Shallow, Flat, Pencil and Corner. Steep/Shallow splits the surface by slope, with a setting for each side.
- Rest roughing is a check box on the 3D pocket: a closing ladder cuts what the levels leave standing. Across setups, the stock can be carried from the previous setup so later checks see what the earlier one left.
- Pencil finishing rides the concave corners that a larger reference ball leaves standing.
The full list of kinds and their settings is on the Operations page; ordering them is covered by Order of operations.