Rigidity, chatter and deflection
The principles
Tool length to diameter. A tool bends like a cantilever: deflection grows with the cube of its stick-out and falls with the fourth power of its diameter. Beyond roughly four times its diameter in stick-out a tool needs lighter cuts, and beyond six or so it needs much lighter ones. A deflected tool cuts a tapered wall, leaving the part wider at the bottom than the top.
Thin walls and floors. A thin wall flexes away from the tool, springs back and then gets cut again, which gives chatter, poor size and a rough finish. A thin floor does the same under axial load.
Leave stock for stiffness, and finish it last. Rough while the part is still a thick, stiff block. Leave a finishing allowance, and cut the thin features to size in a final light pass, ideally in several shallow passes so the wall is supported by uncut material below the tool.
Part movement. Cutting releases stress in the material, and clamping can distort a thin part. Roughing both sides before finishing either, and loosening and re-clamping lightly before a finish pass, are common ways to let it settle.
When it chatters. Chatter is a self-excited vibration: a regular pitch and a wavy surface. Change one thing at a time: reduce radial engagement, shorten the stick-out, check the workholding, and then shift the spindle speed up or down a little (the speed that avoids a resonance is found by trying). Lower feed with the same speed usually makes it worse because the chip gets too thin.
What CamCraft does
- Stock to leave on the Passes tab is the finishing allowance: roughing stops short of the model by that amount, and a later operation finishes it. Order the finish last; see Order of operations.
- Contour tabs (tab count, width and height) keep a profiled part attached to the stock while its outline is cut.
- Stepover, stepdown and engagement are per operation, so a light finish pass on a thin wall is a separate operation with its own settings.
- Holders and stick-out are stored on the tool, and collisions with them are checked (Tool selection).
- Workholding and fixtures belong to the setup, and fixture collisions are checked; see Workholding.
CamCraft does not model tool deflection, part flex or chatter. It cannot warn you that a wall is too thin or a tool too long for a cut. That judgement, and the first-cut check, are yours.