CAM fundamentals
A toolpath is only as good as the machining decisions behind it. These pages explain the challenges every CAM job meets, in general machining terms, and then say plainly what CamCraft does about each one: which setting carries it, what the program gate checks, and what is left to you at the machine.
The principles are general machining knowledge: the standard formulas and the habits a shop passes on. They are not feeds-and-speeds tables. CamCraft does not know your machine, your material lot or your fixture, so where a page says "check", the check is yours. Where CamCraft has no feature for something, the page says so.
- Feeds and speeds
- Tool selection and reach
- Toolpath strategy
- Rigidity, chatter and deflection
- Chip evacuation and coolant
- Surface finish and tolerance
- Proving out a program
- Post and machine quirks
Related guide pages
These topics have pages of their own. The fundamentals pages summarise them and link rather than repeat:
- Order of operations
- Workholding and fixtures
- Machine types
- Multi-axis operations
- Units and coordinates
- Common workflows
- Troubleshooting
- Glossary
- Operations, Setups, Posting and Reading a refusal
- Feeds and speeds - Surface speed, chip load, engagement and chip thinning, and where CamCraft stores and limits them.
- Tool selection and reach - Choosing the shortest tool that reaches, and how CamCraft checks reach and holders.
- Toolpath strategy - Adaptive and conventional roughing, climb and conventional milling, finishing strategies and rest machining.
- Rigidity, chatter and deflection - Why long tools, thin walls and loose setups cut badly, and what to change.
- Chip evacuation and coolant - Getting chips out of deep cuts, and the coolant settings CamCraft writes.
- Surface finish and tolerance - Stepover and scallop height, finish allowance, tolerance settings and holding size across setups.
- Proving out a program - Simulation, verify and what its refusals mean, a dry run, single block and the first-article check.
- Post and machine quirks - The start block, units, tool-centre-point output and checking the first program on a new machine.