CamCraft

CAM fundamentals

Chip evacuation and coolant

The principles

Chips must leave the cut. A chip that stays in a deep pocket or slot gets cut again. That heats the edge, scars the surface and can jam the tool. The risk grows with depth, with narrow slots (where chips have nowhere to go) and with sticky materials.

Deep pockets and slots. Cut in steps of limited depth rather than the full flute length. A slot gives chips only the flute channel to escape, so use a lighter cut, a lower stepdown or a tool with fewer flutes.

Peck drilling. In a deep hole, the drill retracts part way, or fully, between pecks so chips are cleared and coolant can reach the tip. A hole deeper than a few diameters usually needs it.

Air, mist or flood. Flood coolant cools and flushes chips, and suits steel and deep cuts. Mist is lighter. A blast of air clears chips and avoids the thermal shock of intermittent coolant on carbide, a common choice for aluminium and plastics. Through-tool coolant delivers fluid at the tip of a deep hole.

What CamCraft does

  • Peck and deep drilling. The drill kind offers spot, drill, peck, deep, tap and bore cycles, with a peck depth, and a dwell at the bottom.
  • Stepdown limits depth per level in pockets and slots.
  • Coolant is a per-operation choice: Off, Flood (the default), Mist, Air or Through tool. The post switches the machine's own code on for the operation. Air is an air blast that clears chips without a fluid. A choice the machine states no code for, such as air on a machine with no air entry, or through-tool coolant on a machine without it, blocks the post by name, rather than being written as a guess. Coolant modes are declared by the machine file; see Machine types. A machine whose only coolant is air starts new operations on Air.

CamCraft does not model chips, so it cannot tell you that a slot will pack. Read the first cut.