CamCraft

CAM fundamentals

Surface finish and tolerance

The principles

Scallop height. A ball or round-nosed tool stepping across a curved surface leaves a ridge between passes. For a ball of radius R and a stepover s, the ridge height is h = R - sqrt(R^2 - (s/2)^2), about s^2 / (8R). To hit a target height, the stepover is about sqrt(8 R h). Halving the stepover cuts the ridge to a quarter, at twice the cutting time. On a flat floor with a flat end mill the stepover leaves no ridge, but it must still overlap.

Finish allowance. Leave a small, even layer for the finish pass and cut it with a light, constant load. Too little and the finish tool rubs on uneven roughing; too much and it deflects.

Tolerance on the model against the toolpath. The model has dimensional tolerances (what the drawing allows). The toolpath has a tolerance of its own: the largest error from approximating curves with short moves. Keep the toolpath tolerance well inside the part tolerance, say a fraction of it. A tighter value makes bigger programs and slower motion on the machine.

Holding tolerance across setups. Each re-clamp adds position error. Features that must hold a tight relationship are best cut in the same setup, or located from a shared datum such as a bored hole or a machined face.

What CamCraft does

  • Tolerance is a setting on the milling operations. In the 3D finish kinds it is the finish budget: lines and levels are spaced from it, so the cusp stays within it. Where the stepover is Auto, CamCraft computes it from the tolerance and the tool by the scallop law; a stated stepover overrides it.
  • A scallop check on the 3D finish reports a ridge that stands outside the tolerance. It is shown and named on the operation, but it is a quality note and never blocks the post (it is neither a gouge nor a collision).
  • Stock to leave is the finish allowance.
  • Setups carry stock and the work offset between setups (Carry stock and WCS over), and a later setup can see the material an earlier one left. See Setups.

CamCraft does not read tolerances from the model, and it does not check a programmed size against a drawing. The program is a path toward the model's geometry; whether the part meets the drawing is decided by measuring it. The setup accuracy across re-clamps is your workholding and touch-off, not something CamCraft can verify.